P2989 Infiniti Auto Trouble Code
P2989 Infiniti the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
Accelerator Pedal Position Sensor 1 Circuit Low and P2127 - Accelerator Pedal Position Sensor 2 Circuit Low would lead you to suspect a defective accelerator pedal position sensor.
P2989 Infiniti Possible Solution:
Brake Switch Out of Self-Test Range Indicates that during Key On Engine Off (KOEO) Self-Test, BPP signal was high. Or during Key On Engine Running (KOER) Self -Test, the BPP signal did not cycle high and low. Open or short in (BPP) circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit (Rear Electronic Module [REM] Windstar and LS6/LS8 and Lighting Control Module (LCM) Continental and Town Car) Damaged Brake Switch Misadjusted Brake Switch Check for proper function of stoplamps. Follow correct Self-Test procedures, refer to Section 2, Quick Test.
P2989 Infiniti Description For All Models :
- Infiniti Ex35
- Infiniti Fx30
- Infiniti Fx35
- Infiniti Fx45
- Infiniti G20
- Infiniti G35
- Infiniti G37
- Infiniti I30
- Infiniti I35
- Infiniti J30
- Infiniti M35
- Infiniti M45
- Infiniti Q45
- Infiniti Qx4
- Infiniti Qx56
|
P2989 Infiniti Trouble Repair :
P2989 Infiniti code shows that location the body harness connector, located in and around the left hand kick panel area or inside the IP (consult a shop manual for location). Water can leak into the connector from clogged sunroof drains, A-pillar leaks, or windshield or cowling leaks. |
Code Search
Please fill the search bar to find Auto Trouble Code meaning.